Florida plumbing repair, diagnosed before it is quoted

Benefits

• Pinpoint location means smaller, cheaper repairs
• Stops ongoing water damage and mould risk
• Documentation useful for insurance claims
• Ends unexplained spikes in the water bill

Our process

1. 1Isolate the system and confirm a leak is present
2. 2Narrow the location by zone and fixture
3. 3Locate the leak using the appropriate detection method
4. 4Present repair options before any cutting begins

Problems solved

• Warm or damp spots on a slab floor
• The sound of running water with everything shut off
• Water bills climbing without a change in use
• Staining on ceilings, walls or baseboards

Benefits

• Full flow restored, not just temporarily relieved
• Avoids the pipe damage caustic store-bought chemicals cause
• Identifies recurring causes such as bellied lines or roots
• Prevents backups into showers and floor drains

Our process

1. 1Identify whether the blockage is local or in the main line
2. 2Clear the line mechanically
3. 3Camera inspect where blockages keep returning
4. 4Advise on prevention for your specific line

Problems solved

• Slow-draining sinks, tubs and showers
• Gurgling drains or sewer odours
• Multiple fixtures backing up at once
• Recurring clogs in the same drain

Benefits

• Immediate reduction in wasted water
• Protects flooring and subfloor from rot
• Repair or replace advice based on the actual fixture
• Comfort-height and efficient models available on replacement

Our process

1. 1Diagnose the flush, fill or seal fault
2. 2Replace the failed internals or the wax seal
3. 3Reset and level the fixture properly
4. 4Test the full flush cycle before leaving

Problems solved

• Toilet that runs continuously or refills on its own
• Water seeping around the base
• Weak or incomplete flush
• A rocking or loose fixture

Benefits

• Stops water waste from constant dripping
• Restores balanced hot and cold flow
• Cheaper than a full fixture replacement in most cases
• Clean installation when a new fixture is the better call

Our process

1. 1Isolate the fixture and identify the worn component
2. 2Replace cartridges, seats, seals or the fixture as needed
3. 3Check the shutoff valves while access is open
4. 4Test flow, temperature and drainage

Problems solved

• Constantly dripping faucet or shower head
• Handles that are stiff or spin freely
• Reduced flow at one fixture only
• Shutoff valves seized from years of no use

Benefits

• Kitchen back in service the same visit in most cases
• Correct electrical and drain connections
• Prevents cabinet damage from a leaking unit
• Honest guidance on repair versus a new unit

Our process

1. 1Safely isolate power and clear any jam
2. 2Test the motor and reset protection
3. 3Inspect the mounting flange and drain connection for leaks
4. 4Repair or install a replacement unit

Problems solved

• Disposal hums but will not turn
• Water leaking under the sink when the disposal runs
• Persistent odours or slow draining
• Unit trips its reset repeatedly

Benefits

• Water loss stopped fast to limit damage
• Repairs sized to the fault, not the whole house
• Materials suited to local water conditions
• Advice on whether the wider run is at risk too

Our process

1. 1Shut off and isolate the affected line
2. 2Expose the failure point with minimal disruption
3. 3Repair or replace the damaged section
4. 4Pressure test and restore service

Problems solved

• Burst or split pipe
• Pinhole leaks in supply lines
• Cracked or separated drain lines
• Corrosion on aging pipework